Services in Eagle Pass, TX

We measure each opening, recommend the right Andersen window or door for the room and exposure, and handle removal, flashing, insulation, sealing, hardware and trim. Because our installers are Andersen-trained, the work carries a 2-year installation warranty through the Andersen Certified Contractor program, plus the standard Andersen Owner-to-Owner limited warranty on qualifying Andersen products.

Full-frame replacements, insert replacements and new-construction openings are all handled the same careful way: accurate measuring, clean removal, correct flashing and insulation, proper sealing and finished interior and exterior trim so the opening performs and looks right.

Door work starts with a straight, square, properly supported opening. We correct what needs correcting, set the unit plumb and level, seal and insulate it, then adjust the hardware so it latches and swings cleanly. Entry, patio, sliding and interior doors are all part of the same service.

We lay out the run, shim and secure every cabinet to the framing, and set doors and drawer fronts to consistent reveals. Hardware, trim and toe-kick detailing are included, and we coordinate with countertop, appliance and plumbing work so the sequence stays on schedule.

We check the opening, set framed, semi-frameless or frameless glass panels to plumb, anchor hinges and tracks into solid backing, and seal the wet edges so water stays inside the enclosure. Hardware is adjusted and the glass is cleaned before we call it done.

Subfloor preparation, moisture considerations, layout planning, installation and clean transitions between rooms are all part of the job. The result is a consistent, durable floor with tight seams and finished trim rather than a quick cover-up.

A full remodel can include demolition, waterproofing, surrounds, tile and flooring, vanities, fixtures, lighting and glass shower doors. Wet areas are properly waterproofed and trim and transitions are finished so the room reads as one complete piece of work.

Whether the project covers a single room or connected spaces across the house, we plan the sequence, coordinate the work, and keep one point of contact from the first estimate through the final walkthrough.

As a Licensed Residential Appliance Installer with EPA certification for applicable equipment and refrigerant-related work, we confirm the opening, clearances and connections, set and secure the unit, and check that it operates correctly before the space is finished — commonly as part of a kitchen or interior improvement project.

Trim and moulding, doorways, wall repairs, built-in details, finishes and room-by-room improvements, matched to the existing home so new work blends in rather than standing out.

Materials, profiles, proportions and finishes are selected to suit the style you are after — crisp minimal detailing for contemporary spaces, or panelling, casing and trim profiles that respect a colonial home's original character.